CHARACTERISTIC I-V OF Cu/Cu2O SOLAR CELLS WITH BELIMBING WULUH (AVERRHOA BILIMBI L.) ELECTROLYTE USING SUN SIMULATOR

Teuku Andi Fadlly, Fajriani Fajriani Fajriani, Tisna Harmawan Harmawan

Abstract


Characteristic I-V of Cu/Cu2O solar cells with belimbing wuluh (Averrhoa bilimbi l.) electrolyte have been determined using sun simulator data by varying the resistor value (R). The resistor of 1-10 kΩ was applied. The Cu2O layer as a p-type semiconductor is formed by thermal oxidation plate Cu at a temperature of 550 °C. The thermal oxidation time is 80, 100, 120 minutes. Sun simulator measurement result showed that the addition of thermal oxidation time improved the current (I) values, where the most improvement occurred in Cu/Cu2O-100. Furthermore, the current dropped with increasing voltage (V) indicating increase the resistor value. Optimal power (Pout) increases with increasing applied time the thermal oxidation of the Cu plate at 100 minutes. Plotting characteristic I-V give the efficiency (η) of solar cells from samples, and it was found that the Cu/Cu2O-100 reached the highest value, i.e., 2.84 %. In general, the more layers of Cu2O are formed, the higher the efficiency of solar cells.


Keywords


Characteristic I-V; Cu/Cu2O; Belimbing wuluh electrolyte; Sun simulator; Efficiency solar cells

Full Text:

PDF

References


Setiawan F. Pembuatan Prototype Solar Cell Sederhana Menggunakan Bahan Tembaga dengan Media Air Laut. J Tek STTKD. 23 July 2017; 4(1).

Kaur J, Bethge O, Wibowo RA, Bansal N, Bauch M, Hamid R, dkk. All-oxide solar cells based on electrodeposited Cu2O absorber and atomic layer deposited ZnMgO on precious-metal-free electrode. Sol Energy Mater Sol Cells. 1 Maret 2017;161:449–59.

Liu L, Xi Q, Gao G, Yang W, Zhou H, Zhao Y, dkk. Cu2O particles mediated growth of perovskite for high efficient hole-transporting-layer free solar cells in ambient conditions. Sol Energy Mater Sol Cells. 1 December 2016; 157:937–42.

Uranus H. Fabrikasi dan Karakterisasi Solar Cell Oksida Tembaga yang Dibuat dengan Teknologi Sederhana. J Elektro. 1 April 2017;10:53–62.

Lee S-K, Hsu H-C, Tuan W-H, Lee S-K, Hsu H-C, Tuan W-H. Oxidation Behavior of Copper at a Temperature below 300 °C and the Methodology for Passivation. Mater Res. Februari 2016;19(1):51–6.

Soni P. Fabrikasi Sel Surya Berbasis A-Si:H Lapisan Intrinsik Ganda (P-Ix-Iy-N) Dengan Pecvd Dan Analisis Efisiensinya. Institut Teknologi Sepuluh Nopember; 2017.

Karki IB. Effect of Temperature on the I-V Characteristics of a Polycrystalline Solar Cell. J Nepal Phys Soc. 28 Januari 2016;3(1):35–40.

Martil I, Diaz GG. Determination of the dark and illuminated characteristic parameters of a solar cell from I-V characteristics. Eur J Phys. 1992;13(4):193.




DOI: http://dx.doi.org/10.18860/neu.v11i1.5553

Refbacks

  • There are currently no refbacks.


Copyright (c) 2019 Jurnal Neutrino:Jurnal Fisika dan Aplikasinya

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Editorial Address:
Department of Physics, Faculty of Sains and Technlogy, Universitas Islam Negeri Maulana Malik Ibrahim Malang, Indonesia
B.J. Habibie 2nd Floor  
Gajayana st. No.50 Malang 65144
Telp. 082-337-308-100
Email: neutrino@uin-malang.ac.id

Creative Commons License

This work is licensed under CC BY-NC-SA

© All rights reserved 2015. Jurnal Neutrino:Jurnal Fisika dan Aplikasinya (ISSN:1979-6374 , EISSN:2460-5999)

View My Stats

Indeksasi Nasional dan Internasional

        

View My Stats